Fujitsu PRIMERGY MX130 S2 Upgrade and maintenance manua - Concluding Steps

MX130 S2 Upgrade and Maintenance Manual 129
HDDs and accessible drives
Figure 67: Removing the fixation plate of the 5.25-inch ODD/HDD bracket
Ê Remove the fixation plate from the 5.25-inch ODD/HDD bracket.
7.16.4 Concluding steps
Perform the following procedures to complete the task:
Ê Install the 5.25-inch dummy cover as described in section "Installing 5.25-
inch dummy cover" on page 110.
Ê Follow all procedures described in section "Closing the server" on page 54.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section "Enabling
BitLocker functionality" on page 66.