Fujitsu PRIMERGY MX130 S2 Upgrade and maintenance manua - Removing the Processor

192 Upgrade and Maintenance Manual MX130 S2
Processors
11.3.2 Preliminary steps
Before upgrading or replacing the processor, perform the following steps:
Ê Disable BitLocker functionality as described in section "Disabling BitLocker
functionality" on page 59.
Ê Follow all procedures described in section "Opening the server" on page 48.
11.3.3 Removing the processor heat sink
Refer to section "Removing the processor heat sink" on page 189 for removing
the processor heat sink.
11.3.4 Removing the processor
Figure 119: Unlatching the socket lever
Ê Unlatch the socket lever by pushing it slightly away from the socket.
Ê Fold back the socket release lever.