Fujitsu PRIMERGY MX130 S2 Upgrade and maintenance manua - Removing Backup Drive out of 5.25-Inch Chassis Bay; Required Tools; Preliminary Steps

MX130 S2 Upgrade and Maintenance Manual 133
HDDs and accessible drives
7.18 Removing backup drive out of 5.25-inch
chassis bay
7.18.1 Required tools
● Preliminary and concluding steps: tool-less
● Removing a backup drive: tool-less
7.18.2 Preliminary steps
Before removing a backup drive, perform the following steps:
Ê Disable BitLocker functionality as described in section "Disabling BitLocker
functionality" on page 59.
Ê Remove all backup and optical disk media from backup and optical disk
drives as described in section "Removing backup and optical disk media" on
page 60.
Ê Verify if your backup software solution requires preparative configuration
before starting the procedure as described in section "Verifying and
configuring the backup software solution" on page 61.
Ê Follow all procedures described in section "Opening the server" on page 48.
Ê Open the front cage as described in section "Opening the front cage" on
page 52.
Ê Locate the correct drive bay as described in section "Mounting order" on
page 82.