Fujitsu PRIMERGY MX130 S2 Upgrade and maintenance manua - Removing the ODD Filler Cover

MX130 S2 Upgrade and Maintenance Manual 137
HDDs and accessible drives
7.19.3 Removing the ODD filler cover
Figure 73: Removing the ODD filler cover
Ê Using a slotted screw driver, pry the ODD filler cover out of its bay and
remove it from its installation bay.
V CAUTION!
The ODD filler cover is not for future use. You cannot install the ODD filler
cover again.
Do not pry out the ODD filler cover, if you do not install a slimline ODD.