Fujitsu PRIMERGY MX130 S2 Upgrade and maintenance manua - Concluding Steps

MX130 S2 Upgrade and Maintenance Manual 221
System board and components
12.3.5 Concluding steps
Ê Reconnect all cables to the system board. For a complete cabling overview,
please refer to section "Cabling" on page 235.
Ê Reinstall all remaining system board components as shown in the related
sections:
– Memory modules: refer to section "Installing a memory module" on
page 182
I Install all memory modules into their original slots.
– Expansion cards: refer to section "Installing expansion cards" on
page 161
I Install all expansion cards into their original slots.
– TPM board (if applicable): refer to section "Installing the TPM board" on
page 204
Ê Follow all procedures described in section "Closing the server" on page 54.
Ê Reconnect all external cables.
Ê If applicable, activate TPM functionality in the system BIOS under Advanced
> Trusted Computing. For more information, refer to the "Description - BIOS
Manual D3090 / D3091".
Ê If available, update the system board BIOS to the latest version as described
in section "Updating the system board BIOS" on page 62.
Ê Inform the customer about changed MAC addresses. For further
information, refer to section "Looking up changed MAC addresses" on
page 67.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section "Enabling
BitLocker functionality" on page 66.
Ê Enter the required system information using the ChassisId_Prom Tool as
described in section "Using the Chassis ID Prom Tool" on page 68.