40 Upgrade and Maintenance Manual MX130 S2
Important information
The system has a hibernate mode (S4 mode) from which it can be woken up via
WOL (Wake-up On LAN). In order to use this feature, however, the S4 mode
must be activated/enabled in the corresponding operating system installed.
The following description is an example and can only serve as a guide for other
operating systems.
To bring your system into S4 mode (= hibernate mode), proceed as follows:
Operating system Microsoft Windows 2008 Enterprise Edition
Activation
Ê Open the command line tool using C:\Windows\System32\cmd.exe and
enter the following command to activate S4 mode:
powercfg -h ON
Configuration
To set the driver for the internal LAN controller:
Ê Open the Device Manager via Start - Control Panel - System - Device Manager.
Ê Select Network Adapters.
Ê Select the internal LAN controller: Broadcom Netlink™ Gigabit Ethernet.
Ê Select Properties in the overview, and then select Power Management.
Ê In the Wake on LAN field, enable the following option:
– Allow this device to wake the server.
Ê Press OK.
Execution
To execute the power down command in a DOS shell:
Using the shutdown -h command, your system saves all user data (e.g: open
windows and running programs), shuts down the system, and transfers it to S4
mode.
To Next Page
Loading...
