▶
Connect the following cables to the SAS expander board:
1 SAS cable, leading to connector “C0” on the RAID controller
2 SAS cable, leading to connector “C1” on the RAID controller
Figure 104: Connecting the power cable
▶
Connect the power cable to the HDD backplane.
For the cable plan, see "Appendix B" on page 363
.
Concluding steps
▶
Insert all HDD/SSD modules, see "Installing a 2.5-inch HDD/SSD module"
on page 140
.
Make sure that you reinstall the HDD/SSD module in the bay it was
located before the HDD backplane replacement.
▶
Insert all dummy modules, see "Installing a 2.5-inch dummy module" on
page 143.
▶
"Reassembling" on page 53
.
▶
"Connecting the power cord" on page 57.
▶
"Switching on the server" on page 60.
▶
If applicable, "Installing the front cover with lock" on page 61.
Hard disk drive (HDD) / solid state disk (SSD)
RX1330 M5 Upgrade and Maintenance Manual 163
To Next Page
Loading...
