Fujitsu PRIMERGY RX1330 M5 User Manual

Replacing the iRMC microSD card
▶
Remove the defective iRMC microSD card, see "Removing the iRMC
microSD card" on page 308.
CAUTION
(not valid for Europe, Middle East, India and Africa)
The iRMC microSD card contains customer information.
▶
After removing the iRMC microSD card, hand the card over to
the customer.
▶
If the customer requests disposal of the defective microSD card,
proceed as follows: Using a pair of side-cutting pliers, cut the
microSD card in half.
▶
Install the new iRMC microSD card, see "Installing the iRMC microSD card"
on page 306.
Concluding steps
▶
If applicable, install the riser module 1, see "Installing a riser module" on
page
64
.
▶
"Installing the air duct" on page 66.
▶
"Reassembling" on page 53.
▶
"Connecting the power cord" on page 57.
▶
Update the BIOS or iRMC S6 firmware using the iRMC S6 web interface,
see "Updating the BIOS or iRMC S6 firmware using the iRMC S6 web
interface".
▶
"Switching on the server" on page 60.
▶
If applicable, "Installing the front cover with lock" on page 61.
Updating the BIOS or iRMC S6 firmware using the iRMC S6 web interface
This operation will save the firmware image used for firmware restore
feature after system board exchange to the iRMC microSD card.
System board and components
310 Upgrade and Maintenance Manual RX1330 M5

Fujitsu PRIMERGY RX1330 M5 Specifications

General

Processor Sockets	1
Memory	Up to 128 GB
Memory Type	DDR4
Form Factor	1U rack server
Memory Slots	4 DIMM slots
Storage	Up to 4x 3.5" or 8x 2.5" drives
RAID Support	RAID 0, 1, 5, 6, 10, 50, 60
Network	2x 1GbE LAN ports
Power Supply	800W