Fujitsu PRIMERGY TX140 S2 - Installing a 3.5-Inch HDD Dummy Module; Concluding Steps

TX140 S2 Upgrade and Maintenance Manual 139
Hard disk drives / solid state drives
7.3.4.3 Installing a 3.5-inch HDD dummy module
V CAUTION!
If the removed HDD module is not replaced immediately, always replace
a dummy module into the unused HDD bay to comply with applicable
EMC regulations and satisfy cooling requirements.
Figure 57: Installing a 3.5-inch HDD dummy module
Ê Slide the dummy module into the drive bay until it locks in place.
7.3.4.4 Concluding steps
Ê If applicable, "Installing the HDD bay cover" on page 64