TX140 S2
Upgrade and Maintenance Manual 239
Accessible drives
12.2.6 Concluding steps
Ê "Installing the rack front cover" on page 58 (rack server) or "Installing the
front cover" on page 63 (tower server)
Ê "Reassembling" on page 58
Ê "Connecting the server to the mains" on page 67
Ê "Switching on the server" on page 68
Ê If applicable, "Verifying and configuring the backup software solution" on
page 82
Ê "Enabling BitLocker functionality" on page 90
12.3 Removing accessible drives
12.3.1 Preliminary steps
Ê "Disabling BitLocker functionality" on page 69
Ê "Locating the defective server" on page 43
Ê "Removing backup and optical disk media" on page 72
Ê "Verifying and configuring the backup software solution" on page 73
Ê "Shutting down the server" on page 46
Ê "Disconnecting the server from the mains" on page 46
Ê "Getting access to the component" on page 47
Ê "Removing the rack front cover" on page 52 (rack server) or "Removing the
front cover" on page 56 (tower server)
I The front cover only needs to be removed in order to remove or install
accessible drive dummy covers.
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools: tool-less
To Next Page
Loading...
