TX140 S2
Upgrade and Maintenance Manual 215
Main memory
Ê "Disconnecting the server from the mains" on page 46
Ê "Getting access to the component" on page 47
Ê "Removing the fan module" on page 151
Ê Locate the defective memory module using the onboard Local Diagnostic
LEDs (see section "Onboard indicators and controls" on page 322).
10.4.2 Removing the defective memory module
Ê Remove the memory module as described in section "Removing a memory
module" on page 212.
10.4.3 Installing the new memory module
Ê Install the memory module as described in section "Installing a memory
module" on page 213.
10.4.4 Concluding steps
Ê "Installing the fan module" on page 152
Ê "Reassembling" on page 58
Ê "Connecting the server to the mains" on page 67
Ê "Switching on the server" on page 68
Ê If applicable, "Updating or recovering the system board BIOS and iRMC" on
page 75
Ê "Enabling SVOM boot watchdog functionality" on page 85
Ê "Enabling replaced components in the system BIOS" on page 85
Ê "Verifying the memory mode" on page 86
Ê "Enabling BitLocker functionality" on page 90
To Next Page
Loading...
Need help?
General