Fujitsu PRIMERGY TX140 S2 Upgrade And Maintenance Manual

TX140 S2 Upgrade and Maintenance Manual 75
Basic software procedures
5.1.6 Switching on the ID indicator
When working in a datacenter environment, switch on the ID indicator on the
front and rear connector panels of the server for easy identification.
I For further information, refer to section "Locating the defective server" on
page 43 or to the "ServerView Suite Local Service Concept (LSC)"
manual.
Using the ID button on the front panel
Ê Press the ID button on the front panel to switch on the system identification
LEDs.
I For further information, refer to section "Front panel controls and
indicators" on page 327.
Using the iRMC web frontend
Ê Enter the ServerView iRMC web frontend.
Ê Under System Overview, click Identify LED On to switch on the ID indicators.
Using ServerView Operations Manager
Ê In ServerView Operations Manager Single System View and press the Locate
button in the title bar to switch on the ID indicators.
5.2 Completing the maintenance task
5.2.1 Updating or recovering the system board BIOS and
iRMC
After replacing the system board, memory or a CPU, it is essential to upgrade
the BIOS and iRMC to the latest version. The latest BIOS and iRMC versions
are available from the Fujitsu support internet pages at:
http://ts.fujitsu.com/support/ (EMEA market)
http://jp.fujitsu.com/platform/server/primergy/downloads/ (Japanese market)
I Fujitsu does not assume responsibility for any damage done to the
server or for the loss of any data resulting from BIOS updates.

Fujitsu PRIMERGY TX140 S2 Specifications

General

Brand	Fujitsu
Model	PRIMERGY TX140 S2
Category	Server
Language	English