Fujitsu PRIMERGY TX140 S2 - Installing an Expansion Card

178 Upgrade and Maintenance Manual TX140 S2
Expansion cards and backup units
9.4.1.3 Installing an expansion card
Ê Remove the expansion card from its protective packaging.
I For further instructions regarding controller settings, please refer to
the accompanying documentation.
Ê If applicable, attach the required slot bracket to the expansion card as
described in section "Installing a slot bracket" on page 162.
Figure 99: Installing the expansion card (A)
Ê Carefully insert the expansion card into the desired PCI slot and press down
firmly until it is fully seated in the slot.