TX140 S2
Upgrade and Maintenance Manual 77
Basic software procedures
Ê Enter BIOS recovery mode using the onboard jumpers.
I For detailed information on jumper settings, refer to section "Onboard
settings" on page 329.
Ê Close the side / top cover as described in section "Reassembling" on
page 58.
Ê Connect the USB stick to the USB port.
Ê Connect the server to the mains as described in section "Connecting the
server to the mains" on page 67.
Ê Press the On / Off button to start up the server.
The system will detect the USB stick and the BIOS recovery process will be
performed.
V CAUTION!
Do not interrupt the BIOS recovery process after it has started. If the
process is interrupted, the system BIOS may be permanently
corrupted.
Ê After completion of the flash process, shut down the server.
Ê Open the side / top cover as described in section "Getting access to the
component" on page 47.
Ê Disable BIOS recovery mode using the onboard jumpers:
I For detailed information on jumper settings, refer to section "Onboard
settings" on page 329.
Ê Close the side / top cover as described in section "Reassembling" on
page 58.
5.2.1.2 Updating or recovering the iRMC
iRMC flash procedure
I For the Japanese market, follow the instructions provided separately.
Ê Prepare a USB stick including the bootable iRMC firmware update image.
Ê Connect the USB stick to the USB port.
To Next Page
Loading...
Need help?
General