TX140 S2
Upgrade and Maintenance Manual 47
Basic hardware procedures
Ê Disconnect the power cord from the power supply unit and remove it from
the cable tie.
I If you are using a redundant power supply with two power supply units,
proceed with the second power supply unit in the same way.
4.4 Getting access to the component
V CAUTION!
Only valid for the tower model:
Don't lift the server by using the front cover. There is a possibility that the
HDD bay cover hook is broken.
V CAUTION!
●
Before removing or installing covers, turn off the server and all
peripheral devices. Also unplug all power cables from the outlet.
Failure to do so can cause electric shock.
●
In order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
server must not run while the top / side cover is removed.
●
For further safety information, please refer to chapter "Important
information" on page 31.
4.4.1 Rack model
4.4.1.1 Extending the server out of the rack
V CAUTION!
●
Use the anti-tilt plate to prevent the rack from tipping when installing
the rack. Pulling the server out of the rack without having installed the
anti-tilt plate may cause the rack to tip over.
●
Be careful not to pinch fingers or clothes when sliding out the server
or pushing it back. Failure to do so may cause injury.
●
For further safety information, please refer to chapter "Important
information" on page 31.
To Next Page
Loading...
Need help?
General