EasyManuals Logo

Fujitsu PRIMERGY TX140 S2 Upgrade And Maintenance Manual

Fujitsu PRIMERGY TX140 S2
332 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #209 background imageLoading...
Page #209 background image
TX140 S2
Upgrade and Maintenance Manual 209
10 Main memory
Safety notes
V CAUTION!
Do not install unsupported third party memory modules. For further
information on supported memory modules, refer to section "Basic
information" on page 209.
Memory modules remain hot after shutdown. Wait for components to
cool down before installing or removing memory modules to prevent
burns.
Do not insert and remove memory modules repeatedly. Doing so may
cause failures.
Pressing out the securing clips on the memory module connector will
eject the installed memory module. To prevent damage and injuries
eject memory modules carefully without applying excessive force.
For further information, please refer to chapter "Important
information" on page 31.
10.1 Basic information
The system board is equipped with four memory slots.
The system has to be equipped with at least one memory module.
Supported memory modules:
DDR3L 1333 or 1600 unbuffered single rank (SR) or dual rank (DR)
UDIMMs with ECC
Supported capacities: 2 GB, 4 GB or 8 GB.
Maximum amount of RAM: 32 GB

Table of Contents

Other manuals for Fujitsu PRIMERGY TX140 S2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu PRIMERGY TX140 S2 and is the answer not in the manual?

Fujitsu PRIMERGY TX140 S2 Specifications

General IconGeneral
BrandFujitsu
ModelPRIMERGY TX140 S2
CategoryServer
LanguageEnglish

Related product manuals