Fujitsu PRIMERGY TX140 S2 Upgrade And Maintenance Manual

TX140 S2 Upgrade and Maintenance Manual 73
Basic software procedures
5.1.4 Verifying and configuring the backup software
solution
I This task only applies to the Japanese market.
Depending on the backup software solution, it may be necessary to disable or
delete the backup drive from the backup software drive list before starting the
maintenance task.
This is the case for the following backup software solution:
– BackupExec
I Procedures may differ depending on the backup software. For details,
refer to the dedicated documentation provided separately.
Further information on suitable backup software solutions and related
documentation is available to Fujitsu service partners from the Fujitsu
Extranet pages.
5.1.5 Note on server maintenance in a Multipath I/O
environment
When booting your server offline from the ServerView Suite DVD to perform an
offline BIOS / firmware update using the ServerView Update DVD or collect
diagnostic data using PrimeCollect in a Multipath I/O environment, there is a risk
of damaging the system configuration which may leave the system unable to
boot.
This is a known restriction of Windows PE with Multipath drivers.
Before using the ServerView Update DVD or PrimeCollect in an offline
environment, Fujitsu recommends to properly shut down the server and to
disconnect all external I/O connections (like LAN or FC cables) from the system.
Only keep mouse, keyboard, video cable and AC power cord connected.
Continue as follows:
Ê If performing an offline BIOS / firmware update, first of all prepare the
ServerView Update DVD:
Ê Download the latest ServerView Update DVD image from the Fujitsu
FTP server at:

Fujitsu PRIMERGY TX140 S2 Specifications

General

Brand	Fujitsu
Model	PRIMERGY TX140 S2
Category	Server
Language	English