Fujitsu PRIMERGY TX140 S2 - Removing a Memory Module; Concluding Steps

212 Upgrade and Maintenance Manual TX140 S2
Main memory
10.2.2 Removing a memory module
Ê Identify the desired memory slot see section "Memory sequence" on
page 210.
V CAUTION!
Ensure to maintain an operational configuration when removing
memory modules. For additional information, please refer to section
"Basic information" on page 209.
Figure 124: Removing memory modules
Ê Eject the desired memory module by pressing out the securing clips at each
end of the memory slot (1).
Ê Remove the ejected memory module (2).
10.2.3 Concluding steps
Ê "Installing the fan module" on page 152
Ê "Reassembling" on page 58
Ê "Connecting the server to the mains" on page 67
Ê "Switching on the server" on page 68
Ê If applicable, "Updating or recovering the system board BIOS and iRMC" on
page 75
Ê "Enabling SVOM boot watchdog functionality" on page 85
Ê "Enabling BitLocker functionality" on page 90