9100c
9-14 M1207026
• Tighten the mounting screws. Make sure that the top edge of
the switch assembly is parallel to the top edge of the gauge
panel.
10. Test the replacement switch assembly:
• Connect the power cable to an electrical outlet.
• Set the power switch to On.
• Set the system switch to On.
• Make sure that the display comes On.
• Set the system switch to Standby.
• Make sure that the display turns Off.
11. Reinstall the rear panel.
12. Perform the checkout procedure (Section 3).
M1207027 004 MANUAL−DOC, Technical Reference Manual, Technical Reference Manual for 9100c, English−default
Reproduced from the electronic master in MATRIX
To Next Page
Loading...
