GE 9100c - To remove the Vent Engine

9 Repair Procedure
M1207026 9-39
9.17.1 To remove the
Vent Engine
1. Disconnect pipeline supplies; close cylinder valves; bleed off
pressure (Section 9.1).
2. Remove the tabletop (Section 9.3)
3. Disconnect the Vent Engine harnesses.
4. Disconnect the tube.
5. Disconnect the drive gas hose.
6. Loosen the four screws to remove the Vent Engine.
7. To replace the Vent Engine, reassemble in reverse order.
M1207027 004 MANUAL−DOC, Technical Reference Manual, Technical Reference Manual for 9100c, English−default
Reproduced from the electronic master in MATRIX