1 Introduction
M1207026 1-3
1.2 Standard service procedures
1.2.1 User’s
Reference Manual
Some sections of this manual refer you to the User’s Reference
Manual for the 9100c anesthesia machine. To expedite repairs, you
must have and be familiar with the User’s Reference Manual.
Refer to the User’s Reference Manual for further information about
the operation of the system.
1.2.2 Software
versions
The revision levels of the software installed on the control sample
board, the display monitor board and the alarm MCU are displayed on
the main menu of the service mode. This manual includes test and
calibration procedures for Revision 1.x.x.x software of the control
board, Revision 1.x.x.x software of the display board and Revision
1.x.x.x of the alarm board.
1.2.3 Ventilator tests Service calibration functions let GE Healthcare trained users and GE
Healthcare service personnel perform most ventilator setup functions,
tests, calibration, and measurements from the front panel display.
Normal operational tests, calibration, and troubleshooting can be
performed on your 9100c ventilator without removing components
from the system. Repair may require removing the ventilator
components from the anesthesia machine.
WARNING Section 4, "Service Tests and Service Mode" must be
performed whenever you access any internal component
of the ventilator to verify that all critical parts of the
ventilator are still operational and within specification.
WARNING After the ventilator has been serviced, you must perform
Section 3, "Checkout Procedure" to verify the entire
Anesthesia System is properly functioning before the
system can be returned to clinical use.
M1207027 004 MANUAL−DOC, Technical Reference Manual, Technical Reference Manual for 9100c, English−default
Reproduced from the electronic master in MATRIX
To Next Page
Loading...
