GE HEALTHCARERAFT VOLUSON® P8 / VOLUSON® P6
DIRECTION 5459672-100, R
EVISION 6 DRAFT (JANUARY 17, 2013) PROPRIETARY SERVICE MANUAL
5-62 Section 5-15 - LINUX - Voluson Maintenance System
Operation:
1.) Select [Restore] in the displayed “Media Menu” (see: Figure 5-39 above).
NOTE: If the message: “Recovery system (Linux) needs to be updated ...” appears, confirm with YES
.
NOTE: If the currently installed software has to be upgraded to a newer version, and the system DVD being
used is SW 13.0.0 or higher, a new software specific “Permanent key” is required.
2.) Only if you are sure you have saved the “Full System Configuration”, select YES
in the
following dialog box (see: Figure 5-40 below) and confirm with ENTER
.
NOTE: If the message: “Found obsolete image files on R: .... “appears, select YES
and confirm with ENTER.
3.) Recovering will take some time.
Please wait until the final window (Figure 5-41 below) appears and then press ENTER
.
Figure 5-40 Confirm dialog with YES
Figure 5-41 Restore C: done
To Next Page
Loading...
