GE HEALTHCAREDRAFT VOLUSON® P8 / VOLUSON® P6
DIRECTION 5459672-100, R
EVISION 6 DRAFT (JANUARY 17, 2013) PROPRIETARY SERVICE MANUAL
Chapter 7 - Diagnostics/Troubleshooting 7-15
6.) To Enable “Disruptive Mode” select YES.
NOTE: A request is sent to the scanner or workstation asking permission to diagnose the system remotely.
The customer receives the InSite Notification shown below.
NOTE: If the customer does not wish to have diagnostics running at the time of the request, they select NO
.
A message is sent back to the OLC or FE that "Disruptive Mode" is not enabled.
Figure 7-15 enable Disruptive Mode
Figure 7-16 Insite Notification
The customer
selects [Yes]
To Next Page
Loading...
