GRAPHTEC miid LOGGER GL860 - To Cancel Key Lock by Password

3-108
Chapter 3 Settings and Measurement
Contents General Description
Checks and Preparation
Settings and Measurement
Example of Use Specification
13. To cancel key lock by password
A password can be set to GL860 to cancel the key lock.
(No password is set at factory default.)
<Operation flow>
1. Set the password.
Press the " ", and [ENTER] keys at the same time to display the password setting screen shown below.
Specify a 4-digit password.
Use the " " keys to select numbers. Press the [ENTER] key to confirm the password.
Specifying 0000 will disable password operation.
In case you forgot your password, please contact us to acquire the master password.
2. Set the password.
Hold down the " " and " " keys together for at least two seconds.
3. Cancel the key lock.
Hold down the " " and " " keys together again for at least two seconds.
The password setting screen shown below will be displayed. Set a password.
Entering an incorrect password will not cancel the key lock.
The key lock state will be retained when power is turned off.