III
Introduction
5. Notes on Functions and Performance
(1) Be sure to connect the main unit to an AC or DC power supply that conforms to the rated range.
Connection to a non-rated power supply may cause the main unit to overheat and break down.
(2) Do not block the vent on the main unit.
Continued operation with the vent blocked may cause the main unit to overheat and break down.
(3) To avoid malfunctions and other damage, avoid using the GL860 in the following locations.
• Places exposed to high temperature and/or high humidity, such as in direct sunlight or near heating
equipment.
(Allowable temperature range: 0 to 45°C (0 to 40°C when a battery pack is mounted, 15 to 35°C when battery
is being charged), Allowable humidity range: 5 to 85%R.H., non-condensing)
• Locations subject to excessive salt spray or heavy fumes from corrosive gas or solvents.
• Excessively dusty locations.
• Locations subject to strong vibrations or shock.
• Locations subject to surge voltages and/or electromagnetic interference.
(4) If the main unit becomes soiled, wipe it off using a soft, dry cloth.
The use of organic solvents (such as thinner or benzene) causes deterioration and discoloration of the outer
casing.
(5) Do not use the GL860 in the vicinity of other devices which are susceptible to electromagnetic interference.
(6) Measured results may not conform to the stated specifications if the GL860 is used in an environment that is
subject to strong electromagnetic interference.
(7) Insofar as possible, position the GL860 input signal cables away from any other cables that are likely to be
affected by electromagnetic interference.
(8) For stabilized measurement, allow the GL860 to warm up for at least 30 minutes after turning it on.
Notes on the Use of This Manual
(1) All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in
any form or by any means, without the prior written permission of Graphtec Corporation.
(2) The specifications and other information in this manual are subject to change without notice.
(3) While every effort has been made to supply complete and accurate information about this product, please address
any inquiries about unclear information, possible errors, or other comments to your sales representative or nearest
Graphtec vendor.
(4) Notwithstanding the preceding paragraph, Graphtec Corporation assumes no liability for damages resulting from
the use of the information contained herein or of the product.
About Registered Trademarks
Microsoft and Windows are registered trademarks or trademarks of Microsoft Corporation in the U.S. and elsewhere.
Other company names and product names included in this manual are registered trademarks or trademarks of their
respective companies.
Copyright
All copyrights regarding this manual belong to Graphtec Corporation.
To Next Page
Loading...
