GRAPHTEC miid LOGGER GL860 - Safety Precautions

ii
Safety Precautions
Safety Precautions
WARNINGWARNING
Before turning on the GL860, ensure that the electric
socket’s supply voltage conforms to the GL860’s power
rating.
•
Use of a different supply voltage may cause damage to the
GL860 or a fire hazard due to electrical shock or current
leakage.
If the GL860 generates smoke, is too hot, emits a strange
odor, or otherwise functions abnormally, turn off its power
and unplug its power cord from the electrical socket.
•
Use of the GL860 in such status may result in a fire hazard
or electrical shock.
•
After checking that smoke is no longer being generated,
contact your sales representative or nearest Graphtec
vendor to request repair.
•
Never try to perform repair yourself.
Repair work by inexperienced
personnel is extremely dangerous.
Never disassemble or remodel the GL860.
•
Such action may cause a fire hazard due to electric shock
or current leakage.
•
Contact with a high-voltage component inside the GL860
may cause electric shock.
•
If repair is required, contact your sales
representative or nearest Graphtec vendor.
Be sure to securely connect the GL860's GND terminal.
•
After checking that the power switch is turned off, connect
the power cord’s female plug to the GL860 and then
connect its male plug into the electrical socket.
•
For grounding, use a ground wire with a diameter of at least
0.75 mm2. When using the GL860 in an environment where
grounding is not possible, ensure measured is no greater
than 50 V (DC or rms).
Avoid using the GL860 in extremely dusty or humid
places.
•
Such use may cause a fire hazard due to electrical shock or
current leakage.
Avoid using the GL860 in places where it may be
exposed to water such as bathrooms, locations
exposed to wind and rain, and so on.
•
An electrical shock or fire may be caused due
to current leakage.
Prevent dust or metallic matter from adhering to the
power supply connector.
•
Adhesion of foreign matter may cause a fire hazard due to
electrical shock or current leakage.
Never use a damaged power cord.
•
Use of a damaged cord may result in a fire hazard due to
electrical shock.
•
If the cord becomes damaged, order a new one to replace it.
Use prohibited
Use prohibited
No disassembly
Use prohibited
Use prohibited
Watch out for
electrical shock
Watch out for
electrical shock
Avoid water
Watch out for
electrical shock
Unplug the power
cord from the socket