GRAPHTEC miid LOGGER GL860 - Setting the Date and Time

2-37
CHAPTER 2 Checks and Preparation
Contents General Description
Checks and Preparation
Settings and Measurement
Example of Use Specification
2.17 Setting the Date and Time
If you are using the GL860 for the first time, charge the internal rechargeable battery and set the date and time.
If the GL860 is not used for approximately six months, the internal rechargeable battery may be discharged and the date
and time may revert to the initial settings. If this happens, recharge the battery before using the GL860.
CAUTION
How to Recharge the Rechargeable Battery
Using the AC adapter provided, connect the GL860 to a mains power outlet, turn on the power switch, and then leave
the GL860 connected for at least 24 hours.
How to Set the Date and Time
Press the [MENU] key, display the “OTHER” screen, and then set the date and time at the Date/Time.
Settings sub-menu. For details, refer to “Date/Time” in “3.4 Setting Menus”.