GEN7iB
16
SAFETY MESSAGES
SAFETY MESSAGES
2
Maintenance and cleaning
The instrument is a maintenance-free product. However, please note the following
information about cleaning the housing:
● Before cleaning, disconnect the instrument completely.
● Clean the housing with a soft, slightly damp (not wet!) cloth. Never use solvents,
since these could damage the housing or the labeling on the front panel.
● When cleaning, ensure that no liquid gets into the housing or connections.
General dangers, failing to follow the safety instructions
This instrument is a state-of-the-art device and as such is fail-safe. Using this instru-
ment may be hazardous if it has been installed incorrectly and is operated by untrained
personnel. Any person assigned to install, maintain or repair the unit or to put the unit
intooperationmusthaverstreadandunderstoodtheusermanual,particularlythe
technical safety instructions.
Residual risks
This instrument’s scope of supply and performance covers only a small area of mea-
surement technology. In addition, equipment planners, installers and operators should
plan, implement and respond to the safety engineering considerations of measurement
technology in such a way as to minimize any residual risks. Prevailing regulations
must be complied with at all times. The residual risks of the measurement technology
must be referenced.
Conversionsandmodications
Neitherthedesignnorthesafetyfeaturesofthisinstrumentmaybemodiedwithout
ourexpresspriorwrittenagreement.Anymodicationshallexcludeallliabilityon
our part for any resultant damage. In particular, any repair or soldering work on cards
(replacement of components) is prohibited. When exchanging complete units, use only
originalpartsfromHBM.Theunitisdeliveredfromthefactorywithaxedhardware
and/orsoftwareconguration.Changesshouldonlybemadewithinthepossibilities
documented in this manual.
To Next Page
Loading...
Need help?
General
