To Next Page

To Previous Page

GEN7iB

166

INTERFACE/CONTROLLER

11.7 Option - 10 Gbit Ethernet interface (SFP+ Module)

The 10 Gbit Ethernet option is a Factory installed, ready to use Ethernet option with

two available Ethernet interfaces.

The 10 Gbit Ethernet card can be installed in addition to the standard on-board 1 Gbit

Ethernet connection. The 10 Gbit Ethernet card allows you to increase the throughput

speed of communication when compared to the standard 1 Gbit Ethernet. If installed,

the 10 Gbit Ethernet option can replace the use of the standard 1 Gbit Ethernet connec-

tion.

WARNING

Laser Safety

The system is classied as a Class 1 laser product. The SFP uses an optical light source for

data and command communication. It does not emit hazardous light, but direct exposure to

the beam should be avoided.

Fig. 11.17 10 Gbit Ethernet card - with SFP+ module

Notice

The maximum 10 Gbit throughput speed is per-card. Throughput speed is therefore a

shared specication for both interfaces combined. It is possible that two interfaces can be

used at the same time but only when one interface is used for communication and the other

is used for storage. Two interfaces cannot be used at the same time for storage purposes

nor can they be used at the same time for communication purposes.

Questions and Answers:

Need help?

Do you have a question about the HBK GEN7iB GEN Series and is the answer not in the manual?

HBK GEN7iB GEN Series Specifications

General