To Next Page

To Previous Page

GEN7iB

204

INPUT CARDS

12.2.10 GN310B/GN311B type testing of the HV channels

Channel to chassis voltages (and test voltages)

To qualify the insulation as 1000 V CAT III and 600 V CAT IV, certain tests are per-

formedonsomecardsduringtheengineeringdesignqualicationphase.These

tests are known as type tests. These tests are described in the IEC61010-1:2010 and

IEC61010-2-030:2010 standards. The principle of the tests is described below.

For the isolation barrier test, the AC test below (see Fig. 12.27) is used. The test value

meets the requirements for 1000 V CAT III and 600 V CAT IV. Tests are conducted for

5 s (testing electric strength of solid insulation) and 1 minute (long term stress of solid

insulation). For details, please refer to IEC61010-1 and IEC 61010-2-030.





$'&

,VRODWHGFKDQQHO





$'&

,VRODWHGFKDQQHO

&KDVVLV

9506IRUV

9506IRUPLQ

Fig. 12.27 AC type test channel to chassis

Questions and Answers:

Need help?

Do you have a question about the HBK GEN7iB GEN Series and is the answer not in the manual?

HBK GEN7iB GEN Series Specifications

General