GEN7iB
15
SAFETY MESSAGES
SAFETY MESSAGES
2
2 Safety Messages
2.1 Introduction
Impor
Read this section before using this product!
This instrument is mains powered and protective ground connections are required
(unlessotherwisespeciedforcertainparts).
This manual contains information and warnings that must be observed to keep the
instrument safe. The instrument should not be used when environmental conditions
exceedtheinstrument’sspecications(e.g.damp,highhumidity)oriftheunitisdam-
aged.
For the correct and safe use of this instrument, it is essential that both operating and
service personnel follow generally accepted safety procedures in addition to the safety
precautionsspeciedinthismanual.
Whenever it is likely that safety protection has been impaired, the instrument must be
madeinoperativeandsecuredagainstanyunintendedoperation.Qualiedmainte-
nance or repair personnel should be informed. Safety protection is likely to be impaired
if, for example, the instrument shows visible damage or fails to operate normally.
Appropriate use
This instrument and the connected transducers may be used only for measurement
and directly related control tasks. Any other use is not appropriate. To ensure safe
operation,theinstrumentmayonlybeusedasspeciedinthisusermanual.
● The covers protect the user from live parts and should only be removed by suitably
qualiedpersonnelformaintenanceandrepairpurposes.
● The instrument must not be operated with the covers removed.
● This instrument must not be used in life support roles.
● There are no user serviceable parts inside the instrument.
Itisalsoessentialtofollowtherespectivelegalandsafetyregulationsforspecic
applications during use. The same applies to the use of accessories. Additional safety
precautions must be taken in setups where malfunctions could cause major damage,
loss of data or even personal injury.
Some examples of precautions are: mechanical interlocking, error signaling, limit value
switches, etc.
To Next Page
Loading...
Need help?
General
