To Next Page

To Previous Page

GEN7iB

173

INTERFACE/CONTROLLER

Windows

- optimum settings

Impor

tant

To best achieve data transfer rates greater than 200 MB/s please make sure the following

settings are introduced to your network adaptor via the settings in Windows

Windows® 10G network adapter settings:

● Interrupt moderation rate: high

● Receive side scaling queues: 8

● Receive buffers: 2048

Notice

The above Windows

settings were tested and chosen using a specic setup of equipment

(including the Intel

Ethernet Server adaptor x520). These setting may not be the optimal

settings for your specic system.

11.7.1 Installing a 1 Gbit SFP/10 Gbit SFP+ Module

Introduction

This section explains how to install and remove the Small Form Factor Pluggable (SFP

or SFP+) transceiver device from any interface that supports SFP or SFP+ modules.

This device enables an optical network connection to be plugged directly into the front

panel, in the optical network interface of the Interface/Controller. This option is also

required in order to use the 10 Gbit Ethernet card.

Questions and Answers:

Need help?

Do you have a question about the HBK GEN7iB GEN Series and is the answer not in the manual?

HBK GEN7iB GEN Series Specifications

General