HBK GEN7iB GEN Series User Manual

GEN7iB
278
GEN series SYNCHRONIZATION METHODS
GEN series SYNCHRONIZATION METHODS
14
If GEN series recorded data needs to be correlated to other (GEN series) systems that
are not directly synchronized to the same time source, a more accurate absolute time
of day is required to enable data correlation at a later point in time.
Tip
Whenever a GEN series recording is made using any of the available synchronization meth-
ods, the need for absolute time of day synchronization is not required to get a correct signal
phase match.
A typical use of absolute time of day synchronization would be two GEN series sys-
tems, each at different locations that cannot be connected by wires. Using GPS abso-
lute time synchronization would allow recorded data to be compared, even if these two
systems were not connected.
&58

'9,
9$PD[
32:(5287
373
373
&$/
06
,2
0:9SN 0:9SN
       
0:9SN
      
       
0:9SN0:9SN
       
0:9SN
      
       
0:9SN
0:9SN0:9SN
       
0:9SN
      
       
6DWHOOLWH
*36UHFHLYHU *36UHFHLYHU
*36VLJQDO
*(1VHULHVV\VWHP *(1VHULHVV\VWHP
Fig. 14.4 Typical GPS absolute time of day setup

HBK GEN7iB GEN Series Specifications

General

Brand	HBK
Model	GEN7iB GEN Series
Category	Measuring Instruments
Language	English