To Next Page

To Previous Page

GEN7iB

386

TROUBLE-SHOOTING

3. Thenalcrosshairsappearintheupperright-handcornerofthescreen.

A Crosshairs Third crosshairs for calibration.

B DescriptionMoveyourngertothecenterofthetarget,thenliftyournger.

To skip calibrating this monitor, press Esc.

Table of Contents4
About this Manual13
Symbols Used in this Manual13
Manual Conventions14
Safety Messages15
Introduction15
Grounding18
Mains Power Cord19
Instrument Symbols20
Protection and Isolation21
Measurement Categories21
Basic Insulation Versus Reinforced23
Protection25
Overvoltage/Current Protection26
Isolation26
Environment27
Laser Safety28
Manual Handling of Loads29
International Safety Warnings30
Operation of Electrical Installations46
Normative Documents and Declarations47
Electrical47
Electrostatic Discharge (ESD)47
Electromagnetic Compatibility (EMC)48
Environment50
Rohs and WEEE - Waste Electrical and Electronic Equipment50
China Rohs51
CE and UKCA Declaration of Conformity52
CE Declaration of Conformity52
UKCA Declaration of Conformity52
FCC Class a Notice53
Batteries54
General54
Removal and Replacement55
Recharging58
Disposal59
Mains Power60
Power and Frequency Requirements60
Connecting Power61
Fuse Requirements and Protection63
Fuse Replacement64
Introduction66
Introducing Gen7Ib66
Mainframe Overview67
Mainframe Feature Comparison68
Hardware69
PCI-E/Cpci Backplane69
Input Cards70
Master/Sync Support70
Thermal Protection70
Acquisition72
Statstream73
Signal Conditioning74
Data Storage75
PC Section76
Perception Software77
Windows Logon Password and Remote Desktop Access77
Perception Language Settings78
Setting up the Gen7Ib80
PC Connections80
USB 3.0 and USB 2.0 Ports82
Mini Displayports82
Sound82
Removable Drive Bay83
Removing and Installing Input Cards87
Removing Cards87
Installing Cards88
Handle90
Turning the Handle91
Feet92
To Turn the Feet out92
To Turn the Feet in92
Probe Calibration93
DC Power Output95
Digital Event/Timer/Counter97
Isolated Event Adapter101
Torque/Rpm Adapter102
Eaxle Setup104
Accessing the CPU Section105
Air Filter Replacement110
Getting Started112
Front Panel Control112
Getting Started114
Acquisition and Storage115
Introduction115
The Basic Ideas Behind Acquisition Modes in Perception V7 and V8115
Terminology119
Acquistion Modes - User Interface120
Setup for the Acquisition Modes123
On Start of Acquisition123
Wait for Trigger125
Wait for Trigger to Trigger Memory First127
On Start of Acquisition Reduced Rate and Wait for Trigger to Trigger Memory First130
Digital Trigger Modes132
Introduction132
Understanding Digital Triggering133
Digital Trigger Detector133
Valid Trigger Conditions134
Trigger Modes136
Basic Trigger Mode136
Dual Trigger Mode137
Trigger Qualifier138
Recorder and System Trigger139
Channel Alarm140
Interface/Controller141
Introduction141
Communication and Control142
Network Protocols and Ports143
Using the 1 Gbit Option Connections144
Master/Sync Connector145
Connecting the Master/Sync Connector149
Connecting Multiple Mainframes Using the Master/Sync Card150
Setting the Master/Sync Operating Modes152
Synchronizing a Master/Sync Setup to External Time Sources154
I/O Connector155
I/O Connector Input Overvoltage Protection156
I/O Connector Functions and Connector Pinning157
External Start In/External Stop in159
External Event in Use with RT-FDB161
Option - Removable Solid State Drive (SSD)162
Option - Optical 1 Gbit Ethernet Interface164
Option - 10 Gbit Ethernet Interface (SFP+ Module)166
Installing a 1 Gbit SFP/10 Gbit SFP+ Module173
Removing a 1 Gbit SFP/10 Gbit SFP+ Module178
Input Cards179
Available Input Cards179
GN310B (2 Ms/S), GN311B (200Ks/S) Power Analyzer Input Cards182
Measuring Voltages183
Connecting 3-Phase Artificial Star Adapter187
Measuring Currents189
Connecting HBM Current Transducers193
Connecting LEM Current Transducers194
Understanding the GN310B/GN311B Category Rating195
Understanding the GN310B/GN311B High Voltage Input197
GN310B/GN311B Isolation Voltage Channel198
GN310B/GN311B Isolation Current Channel203
GN310B/GN311B Type Testing of the HV Channels204
Isolated 1Kv Input Cards209
GN610B, Isolated 1Kv 2Ms/S Input Card with Real-Time Formula Database209
GN611B, Isolated 1Kv 200Ks/S Input Card with Real-Time Formula Database210
Using the GN610B/GN611B211
Understanding the GN610B/GN611B Category Rating215
Understanding the GN610B/GN611B Input216
Using the High Precision Differential Probe218
Measuring Currents220
GN610B/GN611B Isolation and Type Testing221
GN610B/GN611B Protection Mechanisms230
Isolated Basic/Iepe Cards235
GN815, Isolated Basic/Iepe 2Ms/S Input Card235
GN816, Isolated Basic/Iepe 200Ks/S Input Card236
Using the GN815 and GN816237
Understanding the GN815 and GN816 Isolation239
Understanding the GN815 and GN816 Input240
GN815 and GN816 Input Overload Protection242
Basic High Speed Input Card245
GN8101B/GN8102B/GN8103B, Basic 250, 100, 25 M/S Input Cards245
High Resolution Universal Input Card246
GN840/GN1640 Universal 500 Ks/S 8/16 Channel Input Cards246
Basic Mode and Cabling248
Bridge Mode and Cabling249
Basic Sensor and Cabling253
Integrated Electronic Piezoelectric (IEPE) Mode and Cabling254
Piezoelectric (Charge) Mode and Cabling255
Resistive Temperature Detectors (RTD) Mode and Cabling256
Resistance Mode257
Current Loop Mode and Cabling260
Thermocouple Mode and Cabling261
DIN Rail Breakout262
Flexible Wiring265
Optical Fiber Isolated Input Card266
Gn1202B, Optical Fiber Isolated 100 Ms/S Input Card266
High Resolution IEPE and Charge Input Cards268
GN3210 IEPE and Charge 250 Ks/S Input Card268
GN3211 Basic 20 Ks/S Input Card270
Option Cards272
Option Carrier Card (OCC)272
Option Cards Supported273
GEN Series Synchronization Methods274
GEN Series Synchronization Methods Compared274
Signal Phase Shift Synchronization274
Trigger Synchronization276
Absolute Time of Day Synchronization277
Start/Stop Synchronization279
Synchronization Specification Overview280
Ptp282
PTP Technology Background282
PTP Protocol Details283
Best Master Clock Algorithm (BMC)284
PTP Switch Types286
Transparent Clock Switch Synchronization290
Common Terms Used in IEEE 1588294
PTP and Master/Sync295
Gps297
Installation297
Using the GPS Antenna299
Setup Comparison315
GPS Antenna Placement316
GPS Antenna Lightning Protection318
Trouble-Shooting Guide for G002B318
Irig319
System Overview319
Installation322
Using the GMR1000 Module323
Trouble-Shooting Guide for G001B330
Understanding Inputs and Usage of Probes331
GEN Series Inputs331
Single-Ended Input332
Balanced Differential Input334
Isolated Single-Ended or Isolated Unbalanced Differential Input335
Isolated Balanced Differential Input337
GEN Series Voltage Probe Types339
Passive, Single-Ended Voltage Probes340
Passive, Single-Ended Isolated Voltage Probes342
Passive, Differential Matched Isolated Voltage Probes343
Active Differential Voltage Probes344
Probe Bandwidth Calibration345
Probes345
Probes347
Probes and Differential Measurements348
Current Shunt Measurements349
Areal-Time Formula Database Calculators350
Overview350
Bmaintenance354
Preventive Maintenance354
Preventive Drive Replacement355
Hard Disk Drive355
Solid State Drive (SSD)355
Preventive Air Filter Replacement356
Cleaning357
Cleaning and Disinfecting the Touch Screen358
Cleaning the Touch Screen358
Disinfecting the Touch Screen358
CDC-Recommended Disinfectant Solutions Safe for Touch Screen359
Cservice Information361
General - Service Information361
Calibration/Verification362
Dtrouble-Shooting363
Boot Setup363
GHS Integrated System Image Restore367
Boot Menu Preparation367
Starting Image Restore369
Image Restore Phase 1 - Installing Devices372
Image Restore Phase 2 - Measuring Video Performance372
Image Restore Phase 3 - Windows 10 Welcome373
Potential Problems after Restore380
Touch Screen Calibration383
ELO Touch Screen384
Backing up the Recovery Partition388
Recovery Partition Creation391
Using the Integrated System Recovery USB Disk391
Starting Recovery Partition Creation392
Starting Recovery Partition Restore393
GHS Integrated System BIOS Update396
Language Settings in Windows398
How to Change the Windows398
Installing a Language Pack in Windows 10401
Embedded Software Upgrades410
Boot Recovery Switch410
Unexpected Mainframe Shutdown413
The Master/Sync Connection Does Not Synchronize414
Optical Network (SFP)415
Master/Sync Connection Verification Procedure416
IRIG GMR1000 Trouble-Shooting418
GPS OTMC 100 Trouble-Shooting443
Diagnostics Web464
Efrequently Asked Questions465
Overview465
Frack Mount Instructions466
Mount Gen7Ib in a 19-Inch Rack466
GPTP Synchronization468
Mainframe PTP Connections468
Gen7I468
Gen7Ia/Gen7Ib469
Gen7Ta/Gen7Tb470
Gen2Tb471
Gen4Tb472
Gen3I473
Gen3Ia474
Gen17Ta/Gen17B475
Perception Settings476
Synchronizing GEN Series and Quantumx Using PTP477
Gen3I with Single Quantumx "B" Version Module477
Gen3I with Single Somatxr "B" Version Module478
Gen3I with up to Three Quantumx "B" Version Modules479
Gen3I with Standard Network Switch and Four or more of Quantumx "B" Version481
Modules481
Gen3I with PTP Network Switch and Four or more of Quantumx "B" Version483
Modules483
Gen7Ta/Gen7Tb with Multiple Quantumx "B" Version Modules485
Gen7Ta/Gen7Tb with Single Quantumx "B"; Version Module486
Genesis Using GPS-To-PTP Bridge with Master/Sync Connected Systems487
PTP Grandmasters488
HBK UL-0265 Gigabit PTP Switch489
Siemens Scalance XR234-12M PTP Switch490
Ptp Configuration Errors491
Happlication Specific Usage492
Calculating Maximum Fiber Cable Length492
Wake-On-LAN Support (WOL)494
Locating Gen3I, Gen3Ia, Gen7I, Gen7Ia and Gen7Ib Mac/Physical Address496
Locating Gen3T, Gen7Ta/Gen7Tb and Gen17Ta/Gen17Tb Mac/Physical498
Address498
Eaxle Configuration500
Configuring an Encoder with Direction and Reset502
From Encoder to Level Converter502
From Level Converter to Digital I/O Connector on the Mainframe505
Activate Digital I/O Channels with Perception505

Questions and Answers:

Need help?

Do you have a question about the HBK GEN7iB GEN Series and is the answer not in the manual?

HBK GEN7iB GEN Series Specifications

General

Brand	HBK
Model	GEN7iB GEN Series
Category	Measuring Instruments
Language	English

Related product manuals

HBK MP60

178 pages

HBK GEN7iB GEN Series User Manual

Table of Contents

Questions and Answers:

HBK GEN7iB GEN Series Specifications

Related product manuals