Bed Frame Features
Centrella® Smart+ Bed Instructions for Use (193587 REV 10) 29
Warning—Make sure that the arm is correctly attached in step 4. Otherwise, it may fall. Injury or
equipment damage could occur.
4. Rotate the base tube until the plunger locks into the accessory
socket. You will hear a click when the plunger locks into
position. The blue strain relief faces away from the headboard.
Or
For the P7926A07, from underneath the bed frame, insert the
pin into the slot in the base tube. Install the retaining ring on
to the pin to lock the base tube in position.
5. Connect the Experience Pod® Device communication cable to
the bed.
To Remove
1. Make sure the bed’s brake is set, and a patient is not in the bed.
2. Lower the bed to its lowest position.
To Next Page
Loading...
