Hioki 3159 - Page 4

3.4 Starting a Test 32
3.4.1 Setting the Output Voltage 33
3.4.2 Executing a Test 34
3.4.3 Screening in "TEST" State 36
3.5 PASS or FAIL Determination 37
3.5.1 "PASS" State 37
3.5.2 Screening in "PASS" State 39
3.5.3 "FAIL" State 40
3.5.4 Screening in "FAIL" State 44
Chapter 4 Insulation Resistance Mode Testing
Method 45
4.1 Insulation Resistance Mode Display 46
4.2 Displaying the READY State
48
4.2.1 Key-lock Function 49
4.3 "SETTING" State 50
4.3.1 Setting the Test Voltage Value 51
4.3.2 Setting the Lower (Upper) Limit Value 52
4.3.3 Setting the Test Time 54
4.3.4 Examples of Settings 55
4.4 Starting a Test 58
4.4.1 Executing a Test 58
4.4.2 Screening in "TEST" State 59
4.5 PASS or FAIL Determination 60
4.5.1 "PASS" State 60
4.5.2 Screening in "PASS" State 62
4.5.3 "FAIL" State 63
4.5.4 Screening in "FAIL" State 65
4.6 About the Auto Discharge Function 66
Chapter 5 Auto Test Mode Testing Method 67
5.1 Withstand Voltage Mode Display 68
5.2 Displaying the READY State
70
5.2.1 Key-lock Function 71
5.3 "SETTING" State 72
5.4 Starting a Test
73
5.4.1 Executing a Test 74
5.4.2 Screening in "TEST State" 75