Hioki 3159 - Page 5

5.5 PASS or FAIL Determination 76
5.5.1 "PASS" State 76
5.5.2 Screening in "PASS" State 78
5.5.3 "FAIL" State 79
5.5.4 Screening in "FAIL" State 81
5.6 Auto Discharge Function for insulation resistance
Tests 82
Chapter 6 Optional Functions 83
6.1 PASS Hold Function 85
6.2 FAIL Hold Function
86
6.3 Hold Function
87
6.4 Momentary Out
89
6.5 Double Action
90
6.6 FAIL Mode
91
6.7 RS Command [START]
92
6.8 Inter-lock Function
93
6.9 Voltage Comparator Position
94
6.10 Insulation Resistance Test Measurement Range
95
6.11 Insulation Resistance Test Termination Mode
Settings
96
6.12 Example of Optional Functions Use
98
Chapter 7 Saving/loading Preset Values 99
7.1 Saving Preset Values 99
7.1.1 Procedure for Saving Data 99
7.1.2 Example of Saving 102
7.2 Loading Preset Values 104
7.2.1 Procedure for Loading Data 104
7.2.2 Example of Loading 106
Chapter 8 External Interface 109
8.1 External I/O Terminal 109
8.1.1 Signal Line 110
8.1.2 Example of Input Signal Connection 112
8.1.3 Example of Output Signal Connection 113
8.1.4 Inter-lock Function 115
8.1.5 Timing Chart of External I/O Terminal 117
8.2 Status Out 122
8.3 Buzzer
124