Hioki 7075 - Page 100

90
────────────────────────────────────────────────────
8.3.3 Specific Commands for Output Settings
────────────────────────────────────────────────────
Syntax
:OSET:DELay? <ch>
<ch> Channel number
= 1 to 4 (1 to 2 for the 7075-01)
Response
syntax
(Header ON)
:OSET:DELAY <ch>,<data>
(Header OFF)
<ch>,<data>
Example
Transmission
Response
:OSET:DEL? 1
(Header ON)
:OSET:DEL 1,128000
(Header OFF)
1,128000
Syntax
:OSET:FILTer <ch>,<data>
<ch> Channel number
= 1 to 4 (1 to 2 for the 7075-01)
<data> Frequency of filter
=PASS
F1MHZ 1 MHz
F500KHZ 500 kHz
F200KHZ 200 kHz
F100KHZ 100 kHz
F50KHZ 50 kHz
F20KHZ 20 kHz
F10KHZ 10 kHz
F5KHZ 5 kHz
F2KHZ 2 kHz
F1KHZ 1 kHz
F500HZ 500 Hz
F200HZ 200 Hz
F100HZ 100 Hz
F50HZ 50 Hz
Example
Transmission
:OSET:FILT 1,F100KHZ
Sets the filter for channel 1 to 100
kHz.
Function
Returns the delay for the specified
channel as NR1 numerical data
(number of points).
Note
With this query, if any error occurs, no
response message is produced.
Errors
(Execution error)
When the specified waveform is not
an arbitrary waveform
When sweep is on
Function
Sets the filter.
Errors
(Command error)
When characters are specified other
than those at the left.
(Execution error)
When the specified waveform is a sine
or square wave, or DC
:OSET:DELay?
Queries the delay.
:OSET:FILTer
Sets the filter.