Hitachi WJ200 Series

To Next Page

To Previous Page

4−77

Starting Contact Signal

The inverter gives out the starting contact signal (FR) while it is receiving an

operational command. The FR signal is given out, regardless the setting of the run

command source setting (A002). If the forward operation (FW) and reverse operation

(RV) are given at the same time, the inverter stops the motor operation.

Option

Code

Terminal

Symbol

Function Name State Description

Starting contact

signal

ON Either FW or RV is given, or no operation command

is given

OFF Both FW and RV is given at the same time

alid for inputs:

11, 12, AL0 – AL2 Example for terminal [11] (default output

configuration shown – see page 3-90):

Example for terminal [AL0], [AL1], [AL2] (requires

output configuration – see page 4-52 and 3-90):

See I/O specs on page 4-6

Required settings

Notes:

Forward operation command

Reverse operation command

Starting contact signal (FR)

Inverter output

terminal circuit

CM2 11

AL1

Power

supply

Load

AL0 AL2

Inverter logic

circuit board

Other manuals for Hitachi WJ200 Series