Hitachi WJ200 Series

4−79
Low Load Detection Signal
The low load detection signal output indicates the general status of the inverter output
current. When the output current becomes less than the value specified by C039, the
LOC output turns ON.
Option
Code
Terminal
Symbol
Function Name State Description
43
LOC
Low load detection ON When the output current becomes less than the
value specified by C039
OFF When the output current is more than the value
specified by C039
V
alid for inputs:
11, 12, AL0 – AL2 Example for terminal [11] (default output
configuration shown – see page 3-90):
Example for terminal [AL0], [AL1], [AL2] (requires
output configuration – see page 4-52 and 3-90):
See I/O specs on page 4-6
Required settings
C038, C039
Notes:
General Input (1)~(3)
The functions are for EzSQ. Refer to a manual of EzSQ for detailed description.
Option
Code
Terminal
Symbol
Function Name State Description
44
45
46
MO1
MO2
MO3
General input (1)
General input (2)
General input (3)
ON Each general output is turned on
OFF Each general output is turned off
V
alid for inputs:
11, 12, AL0 – AL2
Required settings
Notes:
Refer to a manual of EzSQ for detailed explanation.
RY
Inverter output
terminal circuit
CM2 11
LOC
AL1
Power
supply
Load
AL0 AL2
Inverter logic
circuit board
LOC