Reset RS input is ON or STOP/RESET key is pressed.
Undervoltage
If input voltage is under the allowed level, inverter
shuts off output and wait with this indication.
Waiting to restart
This indication is displayed after tripping before
restarting.
Restricted operation
command
Commanded RUN direction is restricted in b035.
Trip history
initializing
Trip history is being initialized.
No data
(Trip monitor)
No trip/waning data exists.
Blinking
Communication
error
Communication between inverter and digital
operator fails.
Auto-tuning
completed
Auto-tuning is completed properly.
Auto-tuning error Auto-tuning fails.
NOTE:
Reset is not allowed in 10 second after trip.
NOTE: When error E08, E14 and E30 occur, reset operation by RS terminal or STOP/RESET
key is not accepted. In this case, reset by cycling power. If still same error occurs, perform
initialization.
Warning Codes
If set parameter is conflicted to other parameters, warning code is displayed as follows.
Warning
Code
Warning condition
001
Frequency upper limit (A061)
>
Max. Frequency (A004)
002
Frequency lower limit (A062)
>
Max. Frequency (A004)
005
Output Frequency setting (F001)
Multi-speed freq. 0 (A020)
>
Max. Frequency (A004)
015
Output Frequency setting (F001)
Multi-speed freq. 0 (A020)
>
Frequency upper limit (A061)
025
Frequency lower limit (A062)
>
Output Frequency setting (F001)
Multi-speed freq. 0 (A020)
031
Start frequency (A082)
>
Frequency upper limit (A061)
032
Start frequency (A082)
>
Frequency lower limit (A062)
035
Start frequency (A082)
>
Output Frequency setting (F001)
Multi-speed freq. 0 (A020)
036
Start frequency (A082)
>
Multi-speed freq. 1-15 (A021-A035)
037
Start frequency (A082)
>
Jogging frequency (A038)
To Next Page
Loading...
