Web Client Operation
189
Alarm Center
You can connect your alarm platform to the NVR’s Alarm Center to develop alarm functions.
When a local alarm occurs, the NVR system can upload alarm signals to the Alarm Centre.
1. Click Alarm Center under NETWORK to open the Alarm Center configuration interface.
Figure 12-60 Alarm Center Configuration Interface
2. Before using the Alarm Center, you must configure the Host IP, Port, and Protocol Type.
When an alarm occurs, the NVR system can send data, as defined by the protocol, to the
client. You can also select a Self-report Time interval, or select Never to disable self-
reporting.
3. Click OK to save the settings.
Configuring P2P Settings
You can easily connect to the unit using a mobile device with the HonView Touch app using
the P2P screen. To use this option you will need the HonView Touch app downloaded,
installed, and have registered/created an account. When the app is setup, select to add a
device and use the camera to view the QR code on the P2P screen. The device’s information
and connection will automatically be downloaded to the HonView Touch app and you can now
connect to the NVR using your mobile device.
1. Click P2P under NETWORK to open the P2P interface.
Figure 12-61 P2P Configuration Interface
2. Check the Enable check box.
3. Using a mobile device running the HonView Touch app, select to add a device.
To Next Page
Loading...
Need help?
General
