Honeywell Series A - Page 159

5. Configuration
5.4. Configuring Fieldbus Components In a Control Strategy
R400 Experion PKS Series A Fieldbus Interface Module User's Guide 159
July 2010 Honeywell
Step Action Result
ATTENTION
The Device Identification field is blank until the Project device is matched to an
uncommissioned device. It is shown in the Main tab illustration for example
purposes only.
The Physical Device Tag (PD_TAG) and Device State (DEVSTATE) parameters
on the Main tab are grayed out, since they are only active in the Monitoring tab
after the FIM/LINK/DEVICE is loaded and communicating with the system.
We recommend that you do not change the default value settings for the active
parameters on the System Management form unless you are familiar with tuning
the performance of fieldbus links. In most cases, the parameter values will mirror
those configured for the Link. The grayed out parameters are only accessible in the
Monitoring tab with the FIM/LINK communicating with the system.