Honeywell Series A

To Next Page

To Previous Page

8. Maintenance, Checkout, and Calibration

8.7. Using Fieldbus Device Simulate Function

340 Experion PKS Series A Fieldbus Interface Module User's Guide R400

Honeywell July 2010

Step Action Result

Key in >25< and press <Enter>.

Opens Change Online Value

confirmation dialog.

Click Yes. Sets Simulate Value to 25.

ATTENTION

With R400, the parameter Enable Block Offnet Diagnostic Alarm appears on the

Maintenance tab of Resource blocks, Transducer blocks, and other function blocks

that support block errors. By default, this parameter is disabled, which means that the

Block Offnet Alarm is not reported if a device that contains the block goes off the

network.

Before configuring the Enable Block Offnet Diagnostic Alarm parameter, consider the

following conditions:

If you enable the Enable Block Offnet Diagnostic Alarm, the Block Offnet Alarm is

reported while the device, which contains the block, goes offnet.

If you disable the option while the alarm is active, the alarm returns to normal.

Therefore, you can configure this alarm before loading and it can be changed at

runtime while the device is offline. You can silence the alarm and prevent the

report generation.

Click the OK button. Closes the Block Parameters form.

Honeywell Series A - Page 340