HP 1660 Series User Manual

To remove and replace the HP-IB and RS-232C cables
11 Using previous procedures, remove the following assemblies:
•
Handle
•
Rear Feet
•
Cover
•
Disk Drive
•
Power Supply
•
Rear Panel
22 Remove the two hex standoffs connecting the HP-IB cable, then slide the HP-IB
cable forward and out of the rear panel.
33 Remove the two hex standoffs connecting the RS-232C cable, then slide the RS-232C
cable forward and out of the rear panel.
44 Reverse this procedure to install the HP-IB and RS-232C cables.
Replacing Assemblies
To remove and replace the HP-IB and RS-232C cables
6–14

HP 1660 Series Specifications

General

Category	Logic Analyzer
Glitch Trigger	Yes
Pattern Trigger	Yes
State Analysis	Yes
Transitional Timing	Yes
Trigger Modes	Edge, Pattern, Glitch