To apply power
CAUTION
Electrostatic discharge can damage electronic components. Use grounded wriststraps and
mats when performing any service to the logic analyzer.
11
Check that the line voltage selector, located on the rear panel, is on the correct
setting and the correct fuse is installed.
See also, "To set t he line voltage" on this page.
22
Connect the power cord to the instrument and to the power source.
This instrument is equipped with a three-wire power cable. When connected to an
appropriate ac power outlet, this cable grounds the instrument cabinet. The type of power
cable plug shipped with the instrument depends on the country of destination. Refer to
chapter 7, "Replaceable Parts," for option numbers of available power cables and plug
configurations.
33
Turn on the instrument power switch located on the front panel.
To operate the user interface
To select a field on the logic analyzer screen, use the arrow keys to highlight the
field, then press the Select key. For more information about the logic analyzer
interface, refer to the HP 1660 Seri es Logi c Analyzer User’s Reference.
To set the HP-IB address or to configure for RS-232C, refer to the HP 1660 Seri es
Logi c Analyzer User’s Reference.
To set the line voltage
When shipped from HP, the line voltage selector is set and an appropriate fuse is installed for
operat ing the instrument in the country of destination. To operate the instrument from a
power source ot her t han the one set , perform t he following st eps.
11
Turn the power switch to the Off position, then remove the power cord from the
instrument.
22 Remove the fuse module by carefully prying at the top center of the fuse module
until you can grasp it and pull it out by hand.
Preparing for Use
To apply power
2–3
To Next Page
Loading...
Need help?
General
