Follow these instructions to perform the upgrade by using FTP.
1. Take note of the IP address on the HP Jetdirect page, the second page of the Configuration
page printout.
NOTE Before upgrading the firmware, make sure that the MFP is not in Sleep mode.
Also make sure that any error messages are cleared from the control panel display.
2. Open an MS-DOS command prompt.
3.
Type: ftp <TCP/IP ADDRESS>. For example, if the TCP/IP address is 192.168.0.90, type
ftp 192.168.0.90.
4. Press Enter on the keyboard.
5. When prompted for the user name, press Enter.
6. When prompted for the password, press Enter.
7.
Type bin at the command prompt.
8. Press Enter. The message 200 Types set to I, Using binary mode to transfer files appears in
the command window.
9.
Type put <filename> where <filename> is the name of the .RFU file that was downloaded
from the Web, including the path. For example, type put C:\LJ\4345FW.RFU, and then press
Enter.
NOTE If the file name or path includes a space, you must enclose the file name or path
in quotation marks. For example, type put “C:\MY DOCUMENTS\LJ\4345FW.RFU”
The following series of messages appears in the command window:
200 PORT command successful
150 Opening BINARY mode data connection
226 Ready
226 Processing Job
226 Transfer complete
Then, a message that contains the transfer-speed information appears.
10. The download process begins and the firmware is updated on the MFP. This takes
approximately 5 minutes. Let the process finish without further interaction with the MFP or
computer.
NOTE The MFP automatically turns off and then on again after processing the upgrade.
11.
At the command prompt, type: bye to exit the ftp command.
12.
At the command prompt, type: exit to return to the Windows interface.
ENWW Upgrading the firmware 103
manuals4you.commanuals4you.com
To Next Page
Loading...