HP LaserJet M4345 MFP - Service menu

Menu item Values Description
New Document Feeder Kit (Yes/
No)
Service menu
The Service menu is locked and requires a PIN for access. The PIN code for this MFP is 11434506.
Table 3-18 Service menu
Menu item Description
Clear Event Log Select this item to clear (reset to zero) the internal event log.
Engine Cycle Count Select this item to print a report that displays the number of pages the formatter has
formatted.
Refurbish Cycle Count Select this item to set the page count for a refurbished unit. This page count is stored in
memory so that the correct Service ID can be restored after the MFP is refurbished.
Maintenance Kit Count Select this item to set a) the number of pages that have been printed since the last
maintenance kit was installed, or b) the total number of pages that have been printed on
this MFP if a maintenance kit has not yet been installed (during the first 225,000 pages).
Maintenance Kit Interval Select this item to specify the number of pages that can be printed before a Perform
Printer Maintenance messages appears on the control-panel display to indicate that a
maintenance kit is necessary.
Document Feeder Kit Count Select this item to set a) the number of pages that have been printed since the last
document-feeder kit was installed, or b) the total number of pages that have been printed
on this MFP if a document-feeder kit has not yet been installed (during the first 90,000
pages).
Document Feeder Kit Interval Select this item to specify the number of pages that can be printed before a Replace
Document Feeder Kit messages appears on the control-panel display to indicate that a
document-feeder kit is necessary.
ADF count Select this item to specify the number of pages that have been fed through the document
feeder.
Flatbed Count Select this item to specify the number of pages that have been scanned on the flatbed
glass.
ADF Simplex Count Select this item to set the number of simplex pages that have been fed through the
document feeder.
ADF Duplex Count Select this item to set the number of duplex pages that have been fed through the
document feeder.
Copy Scan Count Select this item to set the number of copy pages that have been scanned.
Send Scan Count Select this item to set the number of scanned pages that have been sent to e-mail.
Copy Pages Count Select this item to set the number of pages that have been copied.
Scanner Settings
CAUTION The scanner settings are used for factory adjustments and should not
be used by service personnel. Use the scanner calibration routine to adjust the
scanner settings if necessary.
Serial Number Select this item to update the serial number if you replace the formatter.
80 Chapter 3 Manage and maintain the device ENWW