6. Disconnect all of the connectors on the DC controller, and then remove three screws (callout 5).
Figure 5-105 Remove the DC controller (5 of 6)
7. Rotate the formatter side of the DC controller away form the MFP. Pull the DC controller out of
the two locking tabs (callout 6) on the fan duct to remove it.
Figure 5-106 Remove the DC controller (6 of 6)
Main motor (M101)
1. Remove the DC controller.
ENWW Internal assemblies 283
manuals4you.commanuals4you.com
To Next Page
Loading...