ADF components
The procedures in this section describe the removal and replacement of the following components:
●
ADF output-bin extension
●
ADF white mylar-backing
●
ADF front cover
●
ADF rear cover
●
ADF left-side cover
●
ADF jam-access cover and latch
●
ADF leading-edge and paper-present sensors
●
ADF hinges
ADF output-bin extension
1. Open the ADF, and remove two screws (callout 1).
Figure 5-182 Remove the ADF output-bin extension (1 of 2)
NOTE Make sure that you store the envelope that contains the clear mylar sheets
under the ADF white, vinyl scan-background after your install the replacement ADF
output-bin extension.
ENWW ADF components 327
manuals4you.commanuals4you.com
To Next Page
Loading...